How do I do this? I tried with the splitter, but when I put a slope on one signal to make a sweep with that signal it affects to whole synth. HELP
How do I do this? I tried with the splitter, but when I put a slope on one signal to make a sweep with that signal it affects to whole synth. HELP
Comments (5)
I put a splitter on a pulv to get it to split into three signals. Then I put one of the wires into an output on a centroid and put another signal from the splitter through a slope and delay and into a separate channel on the centroid. I don't know if it supposed to do this but when I automated the frequency on the slope it affected the whole synth. I thought that the signals were separate and so it would only affect the wire I put into the slope.
I'm new if my question seems weird.
Ok, I fixed it. Needed to add another slope and change the mix.
Could you post a screenshot of the relevant part of your arrangement? What you initially described should be possible to do without extra devices. I use split signals processed differently all the time.
Whoops, you're right. I just tried it and it works. I think I just screwed up the order of my pedals. Thx.