When I automate the milliseconds time on a pulsar delay, as well as the left/right millis, on an undefined curve it gradually gets to its destination point. For example, if the millis is at 5, and suddenly the automation goes to 1, it works its way down to 1. This happens unless it goes to its destination point early. This is detrimental to my sound designs. Please fix.
[[Attachment:0]]
Comments (1)
The knob actually jumps instantaneously, but whenever you change the length of a delay line, you get the artifacts that result from the partial delays still in the feedback loop. If you want an instantaneous change with no artifacts at all, you could set up two pulsars with the different settings and route the signal to each with an automated Splitter or a sequenced Rasselbock.